jlkinser1970
New member
- Joined
- Jun 16, 2023
- Messages
- 4
- Reaction score
- 0
HELP!!!! My girlfriend has a 2011 Chevy Equinox with the 2.4. The Timing chain was starting to rattle so I changed it out. The manifold was cracked so I took it off and replaced the water pump and the manifold. Put everything back together and spun the engine a few times by hand with the crank to make sure nothing locked up. Everything was fine. Went to start the engine and I have a no crank no start situation. I put my scan tool on and got a PO615 Code. Fuses are good, the starter relay is good. I get 11 Volts at one of the relay pins and the rest read in the 2 range. Funny thing is, I pulled the cover off of the starter relay, turned the key to the run position, and pressed the contacts at the relay and bam, she starts right up. Shut it off and tried to restart with the key and nothing. Put the ignition in the start position again, manually touched the relay connectors together and she fired right up again. I have checked all of the grounds and my connections. Everything is connected and tight. I replaced the fuse box today and got the same results. This car will not start with the ignition switch unless I manually manipulate the relay. And of course my girlfriend says, it started fine before you replaced the timing chain and parts. I am LOST!!! Any ideas???
Thanks in advance!!!
Thanks in advance!!!