Reply to thread

Message

<blockquote data-quote="AllTerrain1025" data-source="post: 23273" data-attributes="member: 8486">Got the timing chain replaced last weekend with the Cloyes kit and everything was going good until my daughter told me that the CEL is on. Put the code reader on it and now it is showing a P0017. The car runs perfectly fine and there are no other issues. I have read that sometime using non-GM cam actuators can cause issues, but in looking up the P0017, that point to the Exhaust Cam Position Sensor, which is something I had not touched yet. I am doing an oil change and dropping the pan tomorrow to make sure there are no leftovers from the previous top timing guide and black intake side guide breaking up, but does anyone else have any other ideas or should I throw a Cam Position Sensor at it?And, it is also still showing a P2138 that had gone away after the timing chain was done. For reference in this thread, I have replaced the throttle body and accelerator pedal already. Do not have a scanner good enough to do the actual relearn procedure but did the manual one (3 minutes at ide, off for 10, 3 minutes at idle).</blockquote>

[QUOTE="AllTerrain1025, post: 23273, member: 8486"] Got the timing chain replaced last weekend with the Cloyes kit and everything was going good until my daughter told me that the CEL is on. Put the code reader on it and now it is showing a P0017. The car runs perfectly fine and there are no other issues. I have read that sometime using non-GM cam actuators can cause issues, but in looking up the P0017, that point to the Exhaust Cam Position Sensor, which is something I had not touched yet. I am doing an oil change and dropping the pan tomorrow to make sure there are no leftovers from the previous top timing guide and black intake side guide breaking up, but does anyone else have any other ideas or should I throw a Cam Position Sensor at it? And, it is also still showing a P2138 that had gone away after the timing chain was done. For reference in this thread, I have replaced the throttle body and accelerator pedal already. Do not have a scanner good enough to do the actual relearn procedure but did the manual one (3 minutes at ide, off for 10, 3 minutes at idle). [/QUOTE]

Verification