Reply to thread

Message

<blockquote data-quote="rawhite318" data-source="post: 24130" data-attributes="member: 8903"><p>I can help you out. I have a 2018 and from what I understand they are pretty much the same. On the drivers side under the dash behind the carpet there is a pretty big rubber grommet about 2”X4” if i remember right. If it’s exactly like mine you can pull it out a little BUT when you put it back in spot make sure it’s seated well. On the other side of the firewall you can see the grommet but if you can reach it, it will be tight. I couldn’t so i tied a small rope to the end of a metal hanger that I straighten out. However you puncture the grommet please make sure of two things. 1 don’t nick a wire. You are really close to all the wires that run the vehicle but if you are careful it shouldn’t be a problem. 2 don’t make the hole in the grommet larger than it needs to be. If possible make it small enough that when you pull through the wire it will seal it up. I ran a 0/1 gauge with no problems at all just a couple of days ago.</p></blockquote><p></p>

[QUOTE="rawhite318, post: 24130, member: 8903"] I can help you out. I have a 2018 and from what I understand they are pretty much the same. On the drivers side under the dash behind the carpet there is a pretty big rubber grommet about 2”X4” if i remember right. If it’s exactly like mine you can pull it out a little BUT when you put it back in spot make sure it’s seated well. On the other side of the firewall you can see the grommet but if you can reach it, it will be tight. I couldn’t so i tied a small rope to the end of a metal hanger that I straighten out. However you puncture the grommet please make sure of two things. 1 don’t nick a wire. You are really close to all the wires that run the vehicle but if you are careful it shouldn’t be a problem. 2 don’t make the hole in the grommet larger than it needs to be. If possible make it small enough that when you pull through the wire it will seal it up. I ran a 0/1 gauge with no problems at all just a couple of days ago. [/QUOTE]

Verification