Reply to thread

Message

<blockquote data-quote="Ed.H" data-source="post: 18037" data-attributes="member: 6037">Good Evening members. I'm new to your site and I am looking for some knowledge. Let me say in advance I greatly appreciate any assistance and information that you can send my way.My issue is with my 2014 LT (2.4).Front wheel drive 131.000 MilesI have been hearing some noise coming from the right front when braking all summer and each time I would pull the brakes off and clean things up with light sanding and CRC anti squeak only to have it come back worse each time. Next I replaced rotor and pads (both sides) and bang less then&nbsp; a month and the noise is back.&nbsp; So I finally got around to putting it up on my brothers lift after I started hearing CV axle noise. I found both CV axles&nbsp; were bad along with the lower ball joints. I'm also doing both front hubs while I have it in the air. The Main issue is finding the CV axles..None of the sites I've looked at show the passenger side axle as being longer with the bracket and bearing attached like my vehicle has. I've even tried looking it up as a separate intermediate shaft but none come back as being for my vehicle. I would really rather not got to dealer for this part.($$$$) Has anyone done this job? If so how did the passenger side&nbsp; come, as one long peice or a short CV axle plus an intermediate with the bearing. Thanks again for any assistance.</blockquote>

[QUOTE="Ed.H, post: 18037, member: 6037"] Good Evening members. I'm new to your site and I am looking for some knowledge. Let me say in advance I greatly appreciate any assistance and information that you can send my way. My issue is with my 2014 LT (2.4).Front wheel drive 131.000 Miles I have been hearing some noise coming from the right front when braking all summer and each time I would pull the brakes off and clean things up with light sanding and CRC anti squeak only to have it come back worse each time. Next I replaced rotor and pads (both sides) and bang less then a month and the noise is back. So I finally got around to putting it up on my brothers lift after I started hearing CV axle noise. I found both CV axles were bad along with the lower ball joints. I'm also doing both front hubs while I have it in the air. The Main issue is finding the CV axles..None of the sites I've looked at show the passenger side axle as being longer with the bracket and bearing attached like my vehicle has. I've even tried looking it up as a separate intermediate shaft but none come back as being for my vehicle. I would really rather not got to dealer for this part.($$$$) Has anyone done this job? If so how did the passenger side come, as one long peice or a short CV axle plus an intermediate with the bearing. Thanks again for any assistance. [/QUOTE]

Verification